Lamello Clamex S-20

The Lamello Clamex S-20 is a knock down fitting based on the Clamex-P connector and is connected via a lever.
Unlike the Clamex P which can only be used with the Lamello Zeta biscuit jointer, the S-20 can be used in any 4mm groove cut by any biscuit jointer.

Each half of the connector is secured using 2 screws (supplied seperately) and the lever is accessed via a 6mm hole.
An allignment jig and drill jib are also required.

The design of the fitting was further perfected by introducing two stabilisers which offer strong dimensional stability.
Clamex S-20 has an installation depth of 12.3mm.

Min. Panel Thickness: Mitre joints - 14mm / Butt joints - 16mm
Size: 59 x 12 x 3.9mm
Cutter: 100 x 4 x 22mm

Please select a product

There are no downloads for this product.

Descriptions

The Lamello Clamex S-20 is a knock down fitting based on the Clamex-P connector and is connected via a lever.
Unlike the Clamex P which can only be used with the Lamello Zeta biscuit jointer, the S-20 can be used in any 4mm groove cut by any biscuit jointer.

Each half of the connector is secured using 2 screws (supplied seperately) and the lever is accessed via a 6mm hole.
An allignment jig and drill jib are also required.

The design of the fitting was further perfected by introducing two stabilisers which offer strong dimensional stability.
Clamex S-20 has an installation depth of 12.3mm.

Min. Panel Thickness: Mitre joints - 14mm / Butt joints - 16mm
Size: 59 x 12 x 3.9mm
Cutter: 100 x 4 x 22mm

Specifications

Please select a product

Downloads

There are no downloads for this product.

Reviews

Customers Also Bought

Lamello Clamex S-20 Drill & Alignment Jig

Lamello Clamex S-20 Drill & Alignment Jig